Checklist Logic
In addition to the structure, the Copilot generates the answer logic that fits your request:
- Single choice with variable options.
- Single choice with lines of the type Selection Option, each with its own follow-up lines. Selection option lines are shown in yellow in the draft.
- Multiple choice with Boolean answers.
The Copilot can also fill the Formula Show Line, Mandatory Input, Formula Mandatory Input and Formula Function fields, including Value of Function is Default, Always Overwrite and Automatic Recalculation. It can also set the Formula Show Line of variable options. With each follow-up prompt, the current formulas and logic fields are sent to the Copilot, which is instructed to keep them unless you ask for a change. Review the formula fields in the draft before you confirm.
To try an example, choose the Example: Visibility, mandatory input and calculation action in the Copilot - Generate Checklist Template page.
Logic Status
The draft lines show the Line No. that each line gets after confirmation, the formula fields, the Automatic Recalculation field, and the Logic Status field. Choose the status to see the details. Choose the AssistEdit button in a formula field to open the Formula Editor. Except in the Marked lines scope, you can also change the Type, Input Type, and Level of a line in the draft.
| Status | Meaning |
|---|---|
| OK | No problems were found. |
| Warning | A problem was corrected automatically or is reported as a hint. |
| Error | The formula contains an error, for example unbalanced parentheses, an unknown term, or a comma (,) instead of a semicolon (;) as parameter separator. |
The highest finding of a line determines its status.
Some problems are corrected automatically and reported as warnings. For example, the mandatory setting is removed from lines without input, and visibility conditions below selection options are removed because these lines are hidden automatically.
Other problems are only reported as hints, for example:
- A parent visibility condition is missing in the Formula Show Line.
- The result of a function does not fit the input type.
- A selection option is in the wrong position.
- A variable is used before the line that calculates it.
When you choose Confirm, the logic is checked again. If lines contain formula errors, you can remove the formulas with errors and apply the draft, or return to the draft and correct them.
Note
New options and new Formula Show Line values for existing variables are only written after you confirm them, because they are shared master data. An existing formula in the master data is never cleared.
Structure Check and Recalculation
When the draft is written, the formulas are not calculated. Instead, the structure of the checklist template or version is checked in the same way as with the Check Structure action. For example, every line needs a description, the first line must have level 0 and must not be a selection option, the line after a headline must have the same level as the headline, and the level may increase by at most one from one line to the next. If the check fails, an error message is shown and no changes are saved. Correct the draft, for example the Level of a line, and choose Confirm again. If blocked variables are used, you are asked whether you want to continue.
If the draft turns on Automatic Recalculation for a line that did not have it before, Automatic Recalculation is also turned on in the checklist template or version header, because the automatic recalculation of lines only works if it is turned on there as well.
To calculate the formulas in the checklist template or version, for example to check the default values, choose the Recalculate action. The calculation can stop with an error, for example a division by zero, if a value that a formula uses has not been entered yet.
See Also
Feedback
Submit feedback for this page .