Table of Contents

Consolidation Process

Consolidated test results are calculated per test property from the finished test orders of the same item, variant, and lot or serial number. This topic describes when consolidated results are calculated, which test orders contribute to them, and how the consolidation behavior setup determines whether the calculation runs.

When Consolidated Results Are Calculated

Consolidated results are calculated when a test order on the item level is finished, unless the calculation is postponed for the item. The calculation runs regardless of how the Status field changes to Finished. For example, in the following cases:

  • You choose Finish on the Test Order Card or Test Order List page.
  • You choose Finish Selected Test Orders on the Test Order List page.
  • You change the status of multiple test orders using the Change Test Order Status function.
  • The Test Order Status Usage field in the Test Plan Assignment page skips the Testing Finished status, so the test order is finished directly.

Consolidated results are calculated only for test orders where the Test Destination Type is Item.

Cancelled Test Orders

Cancelling a test order that has Status = Value Recording runs the same closing logic as finishing it. Therefore, consolidated results are also calculated when you choose Cancel for a test order on the item level, unless the calculation is postponed for the item. Test properties that were not yet tested on the cancelled test order are set to No Testing and are not consolidated. The values that were recorded before the test order was cancelled are included in the calculation.

Test Orders That Contribute to a Consolidated Result

The consolidated result of a test property is calculated from the following values:

  • The determined value of the test property on the test order that is processed.
  • The determined values of the same test property on the other test orders that have Status = Finished for the same item and variant. If the processed test order has a lot number or serial number, only finished test orders with the same lot number or serial number are included.

Test properties without a determined value do not contribute to the result. Test properties that have No Testing selected on the test order, or that have no result type, are not consolidated.

The calculation is repeated from the finished test orders each time it runs. A later calculation therefore includes the values of all test orders that were finished since the previous calculation. For information about how values are consolidated for each data type, see Test Results Consolidated - Calculation Types by Data Type.

Consolidation Behavior

The consolidation behavior determines whether the calculation runs when a test order is finished. The behavior is defined in the Test Rslt. Cons. Behav. page and has one of the following values:

  • Calculate: Consolidated results are calculated when the test order is finished.
  • Postpone: The calculation is skipped when the test order is finished. Consolidated results are updated when you run the Update Consolidated Test Results action.

The behavior for a test order is determined by the item in the Test Destination No. field, using the first of the following entries that applies.

Order Entry Result
1 An entry with Type = Item for the item. The Consolidated Result Update Mode of this entry applies.
2 An entry with Type = Item Category for the Item Category Code of the item. The Consolidated Result Update Mode of this entry applies.
3 No entry. The results are calculated (Calculate).

An entry for an item always takes priority over an entry for its item category. An entry applies to all variants of the item. If the item has no item category code, only the item entry is considered.

Examples

The examples in the following table assume that the item category RAW has an entry with Postpone.

Item setup Result when a test order for the item is finished
The item is in category RAW and has no entry of its own. The calculation is postponed.
The item is in category RAW and has an item entry with Calculate. The results are calculated.
The item is not in category RAW and has no entry. The results are calculated.
The item is not in category RAW and has an item entry with Postpone. The calculation is postponed.

For information about how to define the entries, see Test Result Consolidation Behavior.

See Also

Manual Update of Consolidated Test Results
Postponed Consolidation and Customer Certificates


Feedback
Submit feedback for this page .