Manual Update of Consolidated Test Results
The Update Consolidated Test Results action recalculates the consolidated test results for the item, variant, and lot or serial number of a test order. Use this action to update consolidated results that were not calculated when the test order was finished because the consolidation behavior is set to Postpone. For more information, see Consolidation Process.
Where the Action Is Available
The action is available on the pages described in the following table.
| Page | Menu | Available When |
|---|---|---|
| Test Order Card | Actions > Function | The Test Destination Type is Item and the Status is Finished. |
| Test Order List | Actions > Function | The Test Destination Type is Item and the Status is Finished. |
| Test Orders - Finished | Actions | The Test Destination Type is Item. This page lists only test orders with Status = Finished. |
The action is available regardless of the consolidation behavior that is defined for the item. You can also use it for items with the Calculate mode, for example, to recalculate results after the setup or the test data changed.
To update consolidated test results
- Open the Test Order List or the Test Orders - Finished page and choose the Update Consolidated Test Results action from the Actions menu.
- Select a finished test order for the item and lot or serial number.
No confirmation or message is shown when the update is complete. To review the results, open the Test Results Consolidated page from the Lot No. Information or Serial No. Information page. For more information, see Postponed Consolidation and Customer Certificates.
What the Action Recalculates
The action calculates consolidated results for the test properties of the selected test order. For each of these test properties, the results are calculated from the selected test order and all other finished test orders for the same item, variant, and lot or serial number, as described in Consolidation Process.
Consider the following when you use the action:
- Consolidated results are updated only for the test properties that are on the selected test order. Test properties that are on other test orders of the same lot but not on the selected test order are not updated.
- If several test orders were finished while the calculation was postponed, run the action on a finished test order that contains the test properties you need. The calculation includes the values of the other finished test orders for the same item, variant, and lot or serial number.
- Run the action for each lot or serial number that you need results for.
See Also
Test Orders
Test Result Consolidation Behavior
Feedback
Submit feedback for this page .